Working Light Up Ezra Bridger's Lightsaber with Sound | No Paint Required | 3D Printed | Rebel Alliance | Lightsaber Display Mount Offered Stand:3-Desk Display The top will have an

The top will have an emitter screw to hold the blade

This version was used by Tobias Beckett in the trenches of Mimban before he deconstructed his DL-44 and gave it to Han Solo

Start with the lower

Each piece is to be printed and glued separately

Following the Battle of Starkiller Base

Working Light Up Ezra Bridger's Lightsaber with Sound | No Paint Required | 3D Printed | Rebel Alliance | Lightsaber Display Mount Offered Stand:3-Desk Display The top will have anThis is a real working light up replica lightsaber based on Ezra Bridger's first lightsaber. The hilt is 3D printed and assembled for you. Two screws hold the core in place and two halves of the saber together. Unscrew them to gain access to the core for charging. A 1" polycarbonate blade can be attached at the top. It is fairly snug, but a separate contact screw is found in the emitter to tighten the blade into place. If you order the version without